PSA Card Packaging Guidelines


Place each item in a protective flexible pouch (Ex. Card Saver I®). The flexible pouch you choose must be sturdy enough to allow us to remove the item safely.

For the protection of your items, you may want to insert your cards/tickets into a soft card sleeve or mylar before inserting into the Card Saver.

PSA advises against submitting in top loaders, hard acrylic cases or screw down holders.

Submissions received in these types of cases will experience delays in processing and the cases will not be returned with your submission.

Packing Step 1


Packing Step 2

When packaging the items for shipment, please make sure to place the items in the same order they are listed on your Online Submission Center confirmation page.

Items not submitted in the correct order will result in a 5% service charge on your order and longer processing time.

Note: Do not place labels, stickers, or write on the outside of Card Savers. If an item arrives with a manufacturer’s seal/sticker, be advised that PSA will remove it for processing purposes.


Place all your items in between two slightly larger pieces cardboard. Hold the package together with rubber bands. Ensure that the rubber bands are not too tight. They should be just tight enough to hold the cardboard pieces together and prevent the items from falling out.

Packing Step 3

CAUTION: If packed too tightly, the items inside may get damaged.


Protect the items with packing material such as bubble wrap or other shipping/packing material.

Packing Step 4


Pack the items in a new, sturdy cardboard box along with your Online Submission Center confirmation pages. Do not re-use old boxes. If using Styrofoam pellets to pack the items, please be sure the items are kept together in some manner, so they are not scattered about the box when it is opened.

Make sure that they are not packed too tightly. This may cause damage if mishandled.

Use colored packing tape or security tape to completely seal all edges on the outside of the box. Do not use painters tape, scotch tape, or tape that has been previously used.

Packing Step 5


Cut and adhere your Submission ID packing label to the outside of your package. Make sure the barcode is completely visible and is not obstructed with packaging tape. This will allow us to notify you when the package has arrived at PSA.

If you have multiple submissions in one box, please make sure you go back to your Online Submission Center Dashboard to generate a Multi-Submission ID packing Label.

Click here for the Shipping Address

Packing Step 6

PSA strongly advises that you purchase insurance for your collectibles through the courier of your choice for any incoming packages.

Be advised that if the item is poorly packed, is damaged in transit, or shows evidence of tampering, your package may be refused.